Floor-wall construction W1

Profile design floor-wall connection W1
for expansion joints on rising building components with mounting bracket upwards. Raise of the waterproofing membrane to 150 mm above the upper edge of the profile (flashing on request).

System example: VA.8.95/52 F W1

Fitting floor-wall connection W1
if the expansion joint passes directly on rising building components, two corner pieces are required horizontally at the transition from floor-floor to floor-wall (Z-shaped design). 

System example: VA.8.95/52 F W1

Profile design floor-wall connection W1
for expansion joints offset to rising building components with mounting bracket upwards. Raise of the waterproofing membrane to 150 mm above the upper edge of the profile (flashing on request).

System example: VA.8.95/52 F W1

Fitting floor-wall connection W1
if the expansion joint passes offset to rising building components, a fitting profile is required at the transition from floor-floor to floor-wall. A straight (aligned) profile run is therefore given.

System example: VA.8.95/52 F W1